GAP X80 Vertical Amateur HAM Radio Antenna

  • Click to enlarge
GAP X80 Vertical Amateur HAM Radio Antenna

Tap to enlarge


Product Information


The GAP X-80


The GAP X-80 is an end fed aluminium vertical antenna, capable of allowing the user to work 80 metres through 6 metres bands using an ATU, also not requiring any counterpoise and can be fed using coax cable. The antenna can be pole mounted at ground level or elevated depending on the user’s personal requirements. The antenna is rated at 400 watts PEP. The antenna comes complete with all fixings and fixtures and full installation guide.

How it works: The antenna is fed using 50 Ohm coax via a SO-239 socket at the base of the unit. A 6:1 UNUN transformer is located in an IP65 weather sealed box at the bottom of the 6 meter telescopic aluminium element. The transformer reduces the impedance at the feed point to a more acceptable level making the antenna much more efficient and allowing proper and easy tuning via an external ATU and automatic ATU’s found in most modern radios.

The antenna can be grounded if the user experiences excessive local static noise, but as the UNUN is DC grounded: grounding will not affect the tuning ratios.

The Highlighted bands in the chart below will require a manual ATU, the others an internal ATU.


Frequency VSWR

3.5 MHz 80 m with Manual ATU 1.1

7 MHz 40 m with ATU 1.1

10 MHz 30 m , with ATU 1.1

14 MHz 20 m with ATU 1.1

18 MHz 17 m with Manual ATU 1.1

21 MHz 15 m with ATU 1.1

24 MHz 12 m Manual ATU 1.1

28 MHz 10 m with ATU 1.1

50 MHz 6 m with Manual ATU 1.1




Please use a good quality 50 Ohm coax, RG-213 or Mini 8 are probably the best choice.


Type End fed vertical
Frequency TX / 3.5 - 50 MHz 
RX / 1.8 - 55 MHz 
Power handling 400 watts pep
Impedance 50 Ohms
Connector SO-239
Length 6 meters



Product CodeSE JGVE090
Stock Level4

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.

eCommerce by CubeCart